Engineering and Environmental
Analysis of CPT results calibration with CMC test drilling
KOBRZYŃSKA, K., KANTY, P., JAKUBOWSKI, K.
hydraulic pressure KDK, calibration, drilling parameters, replacement parameter, CPT probing
The issue of calibration of the CPT results with test drillings of controlled modulus columns (CMC) columns is widely used in Poland, due to the analogy of drilling parameters for this type of geotechnical research. The values and types of drilling parameters used to correct perform of the calibration depend on the type of the machine executing displacement columns. The issue of calibration is accompanied by problems and technical details that may determine its proper performance. Presentation of three theoretical approaches to searching for one parameter corresponding to the cone resistance chart from the CPT test was developed based on literature and many years’ experience of Menard Polska executing ground improvement in CMC columns technology.
APA style references: Kobrzyńska, K., Kanty, P. & Jakubowski, K. (2018). Analysis of CPT results calibration with CMC test drilling. Scientific Review Engineering and Environmental Sciences, 27 (2), 175-185. doi: 10.22630/PNIKS.2018.27.2.17
APA style citation in text: The first time citation in text: (Kobrzyńska, Kanty & Jakubowski, 2018), next citation: (Kobrzyńska et al., 2018)
Chicago style references: Kobrzyńska, Karolina, Piotr Kanty, Kuba Jakubowski. "Analysis of CPT results calibration with CMC test drilling." Scientific Review Engineering and Environmental Sciences, 80 ser., vol. 27, no 2, (2018): 175-185. doi: 10.22630/PNIKS.2018.27.2.17.
Chicago style citation in text: (Kobrzyńska, Kanty, and Jakubowski 2018)
Bibtxt style references: Bibtxt_utf8_80art8en.bib
in MLA, Harvard, RIS e.t.c styles in CrossRef
Full text PDF